- 170 -Using a Web Browser to Configure the Network Setup4 Under [STEP1], select [Enable] for [IPFiltering].Notez Enabling IP filtering disables all access from hoststhat are outside the range of IP addresses specifiedin [STEP2].5 Under [STEP2], specify the IP addressrange.Notez Using IP addresses, enter the range of hosts thatare allowed to print and configure settings.z For the IP addresses, use single-byte numeralsseparated by periods (.).z Entry of IP address 0.0.0.0. is invalid.z When there is overlap of IP addresses, the addressrange with the highest level set in [Priority] is givenpriority.z Regardless of what is specified in [STEP2], you canuse [STEP3] to specify administrator addressesfor which printing and setting configuration areenabled.6 Click [Address Range Bar Display/Refresh].If you want to modify an IP address range,re-enter the applicable IP addresses, andclick [Address Range Bar Display/Refresh]again.7 Under [STEP3], specify the[Administrator’s IP Address setting].Even if the wrong settings are configuredin [STEP2] due to administrator IP addressentry in [Administrator’s IP Addresssetting], the administrator can re-configurethe setting from a host with the IP addressspecified with [Administrator’s IP Addresssetting].Notez If the printer is being accessed via a proxy, theintermediate device's address will be displayedas [Your Current Local Host/Proxy IP Address].Consequently, the address shown by [Your Host IPAddress] may be different from your actual hostaddress.z If nothing is registered for the administrator IPaddress, the setting in [STEP2] may make theprinter completely inaccessible.z If you do not want to register an administrator IPaddress, leave [Administrator’s IP Address setting]blank.8 Click [Submit].9 Settings are saved on the printer andthe network function is restarted.
