Print media > 25Insert paper in the tray so the side to be printed is facing up and the short-edge of thepaper goes into the printer first.CONFIGURING CUSTOM SIZESTo print on custom size paper loaded in trays 1 to 4, you must set the paper size on thecontrol panel. Use the Menu to set Auto-Sense OFF and then set Custom Size for theintended tray.You may also need to set it in the printer driver, depending on the paper size. Use yourapplication software to send data to be printed on the installed custom size paper. See thedescription of Express Print (see “Express print” on page 32) for an easy way to print onvarious Custom Sizes.To return to standard paper size settings, select Auto. This printer will automatically detectthe size and orientation of the loaded paper.L OADING MEDIALOADING STANDARD SIZE PAPER1. Pull the tray out and place it on a flat surface. If installed, remove the lid.2. If the base plate of the paper tray is raised, push it down.NOTEWhen setting the paper size in the printer driver and control panel, be sure tospecify the same size as the actual paper used. Setting the wrong size forprinting will cause printer failure. This is especially true if you configure abigger size when using a narrow width paper.
