Print media > 295. Adjust the paper guides to fit the transparencies.6. Insert the tray firmly into the printer.7. Using the Control Panel or EWS, select the Transparency Media Type and correctMedia Size for the tray to be used.8. In the printer driver or the computer application program, select Transparency asthe media type you wish to use.ENVELOPESEnvelopes can be printed from all trays. There are 5 sizes of standard envelopes that canbe used. They are COM10, COM9, C5, Monarch, and DL. All other envelope sizes must bespecified as custom size. Only use envelopes designed for use in laser printers. The heatfrom the fuser can melt some adhesives and possibly damage your printer.Loading envelopes into the trays:1. Remove the tray from the printer.2. Insert the envelopes into the tray.3. Adjust the paper guides to fit the envelopes.4. All sizes of envelopes go in all trays with the printing side up and the “flap sidedown”. All envelope sizes except C5 should be placed with the top toward the rightside of the printer. C5 envelopes are available in two configurations. C5 with the flapon the long edge must be placed with the flap toward the right side of the printer. C5with the flap on the short edge must be placed with the flap edge feeding into theprinter. Do not load more than 15 envelopes in Tray 1 or more than 80 in Trays 2.5. Insert the tray firmly into the printer.6. Using the Control Panel or EWS, select the Envelope Media Type and correct MediaSize for the tray to be used.7. In the printer driver or the computer application program, select Envelope as thepaper type you wish to use, and select the size and orientation of the image to beprinted.NOTEAs output transparencies may stick together, remove the transparencies fromthe output tray after about 20 sheets, and then fan them to lower theirtemperature.NOTE> The reverse side of the envelope cannot be printed.> When setting media type from the control panel, ensure Auto-sense is setto OFF.