Panasonic AJ-LT95 Operating Instructions Manual

Contents

Panasonic AJ-LT95 Operating Instructions Manual Manual pdf 52 page image

52Operation methodsAnalog component signals, analog composite signalsand serial component digital signals can be playedback and output using VTR1 and VTR2.Playback using VTR1, VTR21 Set the OPERATION MODE mode switch (page13) to SEPARATE.2 Select AUTO as the setup menu item No.013 (PBFORMAT) setting. If MANU has been selected,select the setup menu item No.012 (SYSFORMAT) setting which matches the format of thetape to be played back.34 When analog video signals are to be output, selectwhether analog component signals or analogcomposite signals are to be output using setupmenu item No.670 (V IN SEL).5 When serial component digital signals are to beoutput, select the VTR for SDI output using setupmenu item No.174 (SDI OUT). (Either VTR1 orVTR2 is selected as the VTR since there is onlyone SDI output system.)6 Set the ANALOG AUDIO OUT switch and connectthe signals to the rear panel connectors asdescribed on page 27.7 If necessary, input the reference video signal to theREF VIDEO IN connector, and use the encodercontrol on the side panel to perform the encoderand/or system adjustments. (See page 23)8 Select the VTR using the VTR1 or VTR2 button,and press the PLAY button.9 To stop playback, select the VTR whose playbackis to be stopped, and press the STOP ([SHIFT] +[PLAY]) button.Playback can also be stopped by pressing the FFbutton and REW button at the same time.VTR2 stops when the ALL STOP button ispressed.Select “525” or “625” as the setup menu itemNo.070 (TV SYSTEM) setting to match the tape tobe played back.O When the “525” or “625” setting has beenchanged, turn off the power and then turn it backon again.O VTR1 and VTR2 cannot be set to different TVsystems.