Panasonic AJ-LT95 Operating Instructions Manual

Contents

Panasonic AJ-LT95 Operating Instructions Manual Manual pdf 61 page image

61Editing without setting the edit IN point (park & edit)Editing can be performed without setting the VTR1and VTR2 IN points.1 Operate VTR1 and VTR2, and locate the placeswhich will serve as the IN points.2 Press the PREVIEW button.The position where the PREVIEW button waspressed is automatically set as the edit IN point,and preview is executed.When the OUT points have not been set either,press the MARK OUT button during the preview atthe place which is to serve as the OUT point.The position where the MARK OUT button waspressed is automatically set as the edit OUT point.To proceed with editing while skipping the preview,press the AUTO EDIT button in step 2 instead of thePREVIEW button, and proceed with editing.The position where the AUTO EDIT button waspressed is automatically set as the IN point, andediting is executed.3 Press the AUTO EDIT button to proceed withediting.Editing using the edit IN point setting only (open-ended editing)1 Set the VTR1 and VTR2 IN points.2 Press the PREVIEW button to proceed withpreview.3 During the preview, press the MARK OUT buttonat the place which will serve as the OUT point.To proceed with editing while skipping the preview,press the AUTO EDIT button in step 2 instead of thePREVIEW button, and proceed with editing.Press the AUTO EDIT button or the MARK OUTbutton at the position where editing is to be ended.The position where the button was pressed isregistered as the OUT point.Auto tag editingWith this editing function, the registered edit OUTpoint is automatically set as the edit IN point of thenext editing session (next event).This enables continuous editing from one event to thenext without the need to set the IN points.This function comes in handy for same positionediting.1 Select REC1, REC2 or ALL as the setup menuitem No.313 (AUTO ENTRY) setting.(This selects the VTR whose IN point is to beautomatically set.)2 Proceed with automatic editing.3 When the editing of one event is completed and itcarries over to the next event, the IN point of theVTR selected in step 1 has already been set sothat the remaining edit points are set, and the nextevent is edited.