Panasonic AJ-LT95 Operating Instructions Manual

Contents

Panasonic AJ-LT95 Operating Instructions Manual Manual pdf 57 page image

57Cut editing operationsStoring the edit pointsSelect the VTR whose edit points are to be setusing the VTR1 button or VTR2 button.There are three main ways to store edit points.2 Use the search dial to search the edit point in theshuttle mode or jog mode.3 Temporarily stop the tape at the edit point, andpress the MARK IN button or MARK OUT button.This sets the edit IN point or OUT point.11. Use the search dial to search theediting screen, and set the edit pointusing the MARK IN or MARK OUTbutton.Select the VTR whose edit points are to be setusing the VTR1 button or VTR2 button.2 Press the IN button or the OUT button.3 Input the desired time code value as a numericvalue.(Press “83209” if this is 8 minutes 32 seconds 09frames.)4 The input value is entered when the ENTER buttonis pressed.12. Use the numeric input buttons to inputthe time codes of the edit pointsdirectly.Select the VTR whose edit points are to be setusing the VTR1 button or VTR2 button.2 After setting the edit IN point, press the DURbutton.3 Input the desired editing period length (duration) asa numeric value.(Press “2607” if this is 26 seconds 07 frames.)4 The input value is entered when the ENTER buttonis pressed.O The set edit points are indicated by the edit pointsetting display lamps (IN lamp and OUT lamp).O If three of the four points—the IN point and OUTpoint for VTR1 and the IN point and OUT point forVTR2—are set, the edit point setting procedure iscompleted.The remaining point will be automatically calculatedwhen editing is performed.13. Specify and set the length (duration ofthe editing period).