6RQT6981Setting upSTEP 2 The remote control≥Insert so the poles (i and j) match those in the remote control.≥Do not use rechargeable type batteries.Do not:≥mix old and new batteries.≥use different types at the same time.≥heat or expose to flame.≥take apart or short circuit.≥attempt to recharge alkaline or manganese batteries.≥use batteries if the covering has been peeled off.Mishandling of batteries can cause electrolyte leakage which candamage items the fluid contacts and may cause a fire.Remove if the remote control is not going to be used for a longperiod of time. Store in a cool, dark place.[Note]If you cannot operate the unit or television using the remote controlafter changing the batteries, please re-enter the codes (television➜page 9, main unit ➜page 46). After plugging the unit into your household AC outlet and pressing[Í, DVD POWER] to turn the unit on for the first time, the unitassists you to set the menu language, and automatically tunes in allthe channels it can receive and sets the clock.The unit automatically determines the type of transmission (air orcable) and puts them into channels as follows.BatteriesUse-+- +PUSH12PUSH123PUSHR6/LR6, AA, UM-3Opening the rear cover.Press with yourfingerClosing the rear cover.Slide into place.When the covercomes offRemote control signal sensor7 m (23 feet) directly in front of the unit30x30x20x20xBand ChannelTV Mode(Air)VHF 2s13UHF 14s69CATV Mode(Cable)VHF 2s13CATV LOW BAND 95s99CATV MID/SUPER BAND 14s36CATV HYPER BAND 37s65ULTRA BAND 66s94100s125SPECIAL CATV CHANNEL 1DVD TVINPUT SELECTVCR Plus+ OPEN/CLOSE TV/VIDEOCHVOLUMESKIPDIRECT NAVIGATOR PLAY LISTTOP MENUENTERMENUFUNCTIONS RETURNSTOP PAUSE PLAY/x1.3SLOW/SEARCHCANCEL1 2 3DVD TV4 5 67 8 90 100FRAME CM SKIP TIME SLIPERASE RECPROG/CHECK ADD/DLTF Rec REC MODESTATUS MARKERAUDIO SETUPDISPLAY POSITIONMEMORYPOWERÍ, DVD POWER3, 4, 2, 1ENTERADD/DLTW, X, CHRETURNSETUPNumberedbuttonsPOWER, Í/I X,W, CHSTEP 3 Plug-in Auto Tuning