MIB DescriptionsC-157612-A2-GB20-00 June 1997Table C-9. Asynchronous Port Table Objects (2 of 2)Object Setting/ContentsDescriptionrs232AsyncPortParity(rs232AsyncPortEntry 4 )Specifies the type of parityused by the port.Supports only the following values:none(1) – No parity bitodd(2) – Odd parityeven(3) – Even parityrs232AsyncPortAutoBaud(rs232AsyncPortEntry 5 )Specifies the ability toautomatically sense theinput speed of the port.Supports only the following values:disabled(2) – Does not supportAutobaud.Synchronous Port Table ObjectsThe Synchronous Port Table contains an entry for the synchronous user data portwhen this port is configured for synchronous operation. For this unit, entries in thetable that are counters (rs232SyncPortEntry 3–7) are used to collect statisticsonly and are not supported. Clarification for objects contained in this table as itapplies to the unit is provided in Table C-10.Table C-10. Synchronous Port Table Objects (1 of 2)Object Description Setting/Contentsrs232SyncPortRole(rs232SyncPortEntry 8 )Specifies whether thisdevice interface is a DTE orDCE.Supports only the following value:dce(2) – The port acts as a DCE.rs232SyncPortEncoding(rs232SyncPortEntry 9 )Specifies the bit encodingtechnique that this portuses.Supports only the following value:nrz(1) – The port uses non-return tozero encoding.rs232SyncPortRTSControl(rs232SyncPortEntry 10 )Specifies the method usedto control the RTS signal.Refer to Data Port Options,Table A-3.Supports only the following values:controlled(1) – For User Data port, thisvalue is used when the Data Port optionCarrier Control by RTS is set toSwitched.constant(2) – For User Data port, thisvalue is used when the Data Port optionCarrier Control by RTS is set toConstant.
