Configuration Option TablesA-157612-A2-GB20-00 June 1997Table A-7. General SNMP Management Options (2 of 2)Community Name 2Possible Settings: ASCII Text, ClearDefault Setting: [blank]Community Name of external SNMP Managers allowed access to the DSU’s MIB. Thiscommunity name must be supplied by an external SNMP manager attempting to accessa MIB object. Level of access is set in the next option, Name 2 Access.ASCII Text – Enter a maximum of 130 ASCII printable characters. Refer toEnteringDevice and System Information in Chapter 3.Clear – Clears the Community Name 2 field.Name 2 AccessPossible Settings: Read, Read/WriteDefault Setting: ReadSet the access level for the Community Name 2 created in the previous option.Read – Allows a read-only access (SNMP Get, Getnext) to accessible MIB objects.Read/Write – Allows SNMP Get, Getnext, and Set functions on MIB objects. Writeaccess allowed to all MIB objects specified as read-write in the MIB RFC.SNMP NMS Security OptionsFor SNMP NMS Security Options, refer to Table A-8. To access the SNMP NMSSecurity Options screen, follow this menu selection sequence:Main Menu →Configuration →Load Configuration From →Edit →SNMP →SNMP NMS SecurityTable A-8. SNMP NMS Security Options (1 of 2)NMS IP ValidationPossible Settings: Enable, DisableDefault Setting: DisableDetermines if security checks are performed on the IP address of any SNMPmanagement system that attempts to access the node.Enable – Performs security checking. Allows access only if the sending manager’sIP address has been entered in the NMS IP address list.Disable – No security checking of incoming SNMP messages.Number of ManagersPossible Settings: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10Default Setting: 1Set the number of SNMP managers that are authorized to send SNMP messages. TheIP address of each SNMP management system must be entered in the next option.1 to 10 – Specifies the number of SNMP managers allowed to send SNMP messages.