Configuration Option TablesA-97612-A2-GB20-00 June 1997Table A-3. Data Port Options (3 of 3)Monitor DTRPossible Settings: Enable, DisableDefault Setting: EnableIndicates to the DSU whether to monitor the Interchange Circuit CT108, Data TerminalReady (DTR), from the DTE.Enable – The DSU monitors the state of DTR on the User Data (DTE) port. Based onthe Link Traps option setting in Table A-9, the DSU uses the DTR circuit to trigger a LinkUp/Down SNMP trap and a Health and Status message.Disable – DTR is not monitored by the DSU. Use when a DTE does not provide theDTR lead at the interface.Ethernet Port Options MenuFor Ethernet Port Options, refer to Table A-4. To access the Ethernet PortOptions screen, follow this menu selection sequence:Main Menu →Configuration →Load Configuration From →Edit →Ethernet PortTable A-4. Ethernet Port Options (1 of 2)Port UsePossible Settings: 802.3, Version 2, DisableDefault Setting: Version 2The Ethernet port provides a choice of functions.802.3 – Configures the DSU to use IEEE 802.3 format.Version 2 – Configures the system to use Ethernet Version 2 format.Disable – Data received on this port is ignored. No other fields in this table will appear when set to Disable.IP AddressPossible Settings: 000.000.000.000 – 223.255.255.255, ClearDefault Setting: 000.000.000.000Specifies the IP (Internet Protocol) address used to identify the Ethernet port. Eachthree-digit decimal number represents a byte.000.000.000.000 – 223.255.255.255 – Enter an address. The range for the first byte is000 to 223, with the exception of 127. The range for the remaining three bytes is 000 to255.Clear – Clears the IP Address and sets to all zeros.
