C o n f i g u r a t i o n 79Configure Congestion ParametersTo configure Congestion Parameters, follow the steps below.1 Type “3” on the Frame Relay Options menu to display the Fame RelayCongestion Configuration menu (Figure 4.49).Figure 4.49 Frame Relay Congestion Configuration Menu2 Select Configure Transmit Congestion Parameters and then follow the on-screen messages to• FECN/BECN condition set size• FECN/BECN condition clear size• FECN/BECN max number of bytes to store− or −Select Configure Receive Congestion Parameters and then follow the on-screen messages to• FECN/BECN condition set size• FECN/BECN condition clear size• FECN/BECN max number of bytes to store4 Reset the IAD for changes to take effect.Enable/Disable CopperMountain CMCPNOTICE: When using a CopperMountain DSLAM, CMCP allows the DSLAM toconfigure many IAD parameters automatically. IAD parameterscontrolled by CMCP include fragmentation and voice gateway support.For more information, refer the CopperMountain DSLAM guide.1 Type “4” on the Frame Relay Options menu. The IAD displays the CMCPstatus and prompts you to change it.2 Type “E” to enable CopperMountain CMCP or “D” to disable.Router ConfigurationThis section describes how to configure the IAD as a router. You mayconfigure the IAD as a router or a bridge, depending on your application.
