86 2 0 0 0 - A 2 - G B 2 3 - 0 0Enable/Disable RIPWhen you enable RIP, the IAD sends routing data to adjacent routers anddynamically learns the associated network topology. To enable RIP globally,follow the steps below.1 Type “R” on the Router Configuration menu (Figure 4.51), to selectEnable/Disable RIP. The IAD displays the RIP current status and promptsyou to enable or disable RIP globally.2 Type “E” to enable RIP globally, or “D” to disable it globally. The IADsaves the configuration and displays the Router Configuration menu (Figure4.51).3 Continue with other configuration tasks, or press Escape to return to theMain menu.NOTICE: For RIP to function correctly, you must enable RIP globally or locally(by port) and set the RIP version. The order in which you perform eachprocedure is irrelevant.Configure RIP Version by PortTo configure RIP Version by Port, follow the steps below.1 Type “V” on the Router Configuration menu (Figure 4.51) to selectConfigure RIP Version by Port. If more than one WAN port is installed ormore than one PVC/DLCI exists, the IAD displays the interfaces on thisIAD (sample shown in Figure 4.52).2 Type the interface number to set. The IAD displays the port table for thisinterface and prompts you to select a port:3 Type the port number to set and press Enter. The IAD displays the RIPconfiguration and status of the slot and port you’re setting, and prompts youto select a new version:4 Type the option number of the version to set. Setting the RIP version for thisport is complete. The IAD saves the settings and displays the RouterConfiguration menu (Figure 4.51). Repeat these steps for each remainingport to set.5 Continue with other configuration tasks, or press Escape to return to theMain menu.Configure RIP Poisoned Reverse by PortTo configure RIP Poisoned Reverse by port, follow the steps below.1 Type “P” on the Router Configuration menu (Figure 4.51) to selectConfigure RIP Poisoned Reverse by Port. The IAD displays the interfaceson this IAD (sample shown in Figure 4.52)2 Type the number of the port to enable or disable. The IAD displays the RIPstatus of this port and prompts you to enable or disable RIP PoisonedReverse for that slot and port.