A d m i n i s t r a t i o n 35Figure 3.5 File Transfer Menu3 Type “X” to update the entire system (you must use TFTP).4 Respond by typing “Y” to continue.5 The IAD prompts you to enter the IP address of the TFTP Server.6 Type the IP address of the TFTP Server and press Enter.As file transfer progresses, the IAD reports the status of each file beingcopied. Two files − acos.bin and boot.bin − will only be copied if they matchthe platform to guard against loading incorrect system files onto an IAD.NOTICE: If the IAD cannot locate the first file to download (typicallyrelease.dat), the update will fail. Make sure you have assigned a validIP address and subnet mask, and you’re on the same subnet as theTFTP Server. Use the Ping command to ping the IAD and try again.Upon completion, the IAD reports the success or failure of each file transfer,and then reports the completion of file transfer and resets.Verifying the UpgradeTo verify that the files downloaded successfully after being transferred,observe the boot sequence. The IAD displays the software version in theParadyne banner.You may also display the current configuration to validate the firmwareversion.Utilities MenuThe Utilities menu contains utility commands, including several menus toupgrade IAD software and support ACOS application development.To display the Utilities menu, type “9” on the Main menu.
