206 2 0 0 0 - A 2 - G B 2 3 - 0 0Testing the IAD1 Verify the WAN link status:• SDSL Interface—the LINK indicator blinks while the IAD synchronizes withthe DSLAM, and lights continuously when the link is established.• T1/E1 Interface—the LINK indicator blinks while the IAD synchronizeswith the voice gateway, and lights continuously when the link isestablished.2 Connect a POTS telephone to a provisioned line port on the IAD.3 Lift the telephone receiver and check for dial tone. If no dial tone is present,troubleshoot as necessary. (See Troubleshooting the IAD on page 7-201.)4 Repeat steps 2 and 3 for each provisioned line port.5 Disconnect the telephone once you are through testing the line ports.6 Use a crossover cable to connect the PC to the Ethernet LAN port on theIAD. Determine that the PC is configured with an IP address on the samesubnet as the IAD.7 Observe that the LINK indicator on the IAD front panel lights to verify thatthe IAD is connected to the LAN.8 Run Ping on the PC to ping a known good address on the IAD and verify theacknowledgement. If a timeout occurs, troubleshoot the LAN path to theIAD.9 Ping a known good address on the network and wait for acknowledgement.If a timeout occurs, troubleshoot the LAN path to the IAD.10 Disconnect the Ethernet cable between the PC and the IAD.11 Using a straight-through cable, connect the Ethernet LAN port on the IADto your local LAN patch panel or hub|switch|router.12 Connect the IAD telephone ports to the local distribution frame or patchpanel.The IAD is ready for service.MaintenanceThe IAD menu interface contains utilities reserved for factory maintenanceand development. Before running any System Utilities, consult your technicalsupport representative.Displaying the Current ConfigurationTo display the current configuration and data transmission status, follow thesteps below.1 On the Main menu, type “1” to display the Reports menu.
