Configuration via PC using "ServoManager"Installing ServoManager91UnithardwareConnectorassignment / cableTechnical dataConfigurationPositioning andcontrol functionsOptimizationfunctionsInterfacesAccessories /optionsStatusParameterError list8.3 Configuration via PC using "ServoManager"There is a separate manual describing how to work with ServoManager.8.3.1 Installing ServoManagerBefore installation, deactivate the following programs:♦ any virus detection software.♦ the Miro Pinboard in Miro graphic cards.Information concerning these programs.Following installation, the virus software can be reactivated.Problems may also occur during program execution with Miro Pinboard.Start the "Setup.exe" program on disk 1. The installation is a menu-guided process.Following the installation, a Windows program group will appear containing theServoManager and the terminal.8.3.2 Configuring COMPAX♦ Create connection to COMPAX: cable SSK1 (see Page 59).♦ Call up ServoManager.♦ Create a new project (Menu: Project: New).♦ Using the menu "Axis: Insert: From controller" to set up an axis which contains allCOMPAX settings (all parameters: including system parameters and datarecords, curves are also available for COMPAX XX70).♦ Use the menu "Servo-Tools: to switch to ParameterEditor.♦ Call up menu "Configuration: Guided configuration".All configuration parameters are queried one after another.8.3.3 Individual configuration of synchronous motorsIn addition to the motors contained in ServoManager / ParameterEditor, you canconfigure almost all synchronous motors. The conditions required for the motorsand resolvers are listed in the start-up manual under "Technical data".To modify motor parameters, the motor must be switched off (use OUTPUT O0=1or press the "-" button on the front plate while switching on COMPAX).You will find the data required for this on the HAUSER motor type plate.PreparationInstallation
