Regency City CV60E-1 Owners & Installation Manual

Also see for City CV60E-1: Owners & installation manual

owner's information16 | City Series CV60E-1Proflame II Remote Control Operating InstructionsThe Proflame 2 Transmitter controls the following hearth appliancefunctions:1. Main burner on/off.2. Main burner flame modulation (6 levels).3. Choice of standing or intermittent pilot (CPI/IPI) (non power ventonly).4. Thermostat and smart thermostat functions.5. Accent light modulation (6 levels).6. Split flow valve (not available).7. On/Off relay.8. Comfort fan speed modulation (6 levels) (not available).Figure 1: Transmitter LCD DisplayTECHNICAL DATAREMOTE CONTROLSupply voltage 4.5V (three 1.5V AAA batteries)Ambient temperature rat-ings0 - 50oC (32 - 122oF)Typical operative distancein free air12 m (39 ft)Radio frequency 315 MHZ (FCC version)Non-Power Vent Model: Install the 4 AA batteries during power out-ages to run the main burner. However, the lights will not operate.Power Vent Model: This appliance will not operate if 120 volt poweris lost within the home.This appliance requires coding/pairing of the remote control and IFC(Integrated Fireplace Control). See instructions in this manual.Figure 3: Battery compartmentPairing the remote control to remote receiver/batteryholder (if required)Power the receiver and press the PRG button located on its top rightcorner - see the receiver instruction marked (*). The receiver will beepthree times when ready to synchronize with a transmitter. Install threeAAA batteries in the battery bay, at the base of the transmitter (fig. 3).Press the ON button. The receiver's command is accepted and sets tothe particular code of that transmitter. The system is now initialized.(*) The receiver may be independent or integral to the IFC hearth appli-ance control module. The receiver instruction may not be independentwhen part of the IFC.Figure 2: Proflame TransmitterThe Proflame Transmitter uses a streamlined design with a simple buttonlayout and informative LCD display (fig. 1). A mode key scrolls betweenthe features and a thermostat key is used to turn on/off or scroll throughthermostat functions (fig. 1 & 2). There is also a key lock feature (fig. 22).NOTES The Proflame Transmitter 2 is an integrated part of the Proflame2 System, which consists of these elements:» Proflame 2 Transmitter, in conjunction with» Integrated Fireplaces Control (Proflame 2 IFC)WARNING The transmitter and IFC are radio frequency devices.On/off key Thermostat KeyUp/Down Arrow KeyMode KeyBack lit LCD displayATTENTION • Turn OFF the main gas supply of the applianceprior to installation or maintenance of the IFC, andremoving or reinserting the batteries.• In case of remote control malfunction, turn off theIFC device using the ON/OFF main switch.• For installation / maintenance, switch off the IFCdevice removing main power supply plug.