Regency City CV60E-1 Owners & Installation Manual

Also see for City CV60E-1: Owners & installation manual

70 ............................................. |City Series CV60E-1installation70 | City Series CV60E-1Inner Glass Panel (Firebox Glass) Installation / Removal1. Remove outer safety barrier glass panels if previously installed–see instruc-tions in this manual.2. Remove outer panels installed in unit - see panel removal section in this manual.3. From the front inside lower panel of the unit--pivot the 3 glass supportsinto upright position as shown below.WARNING: GLASS HANDLINGWe recommend using the glass vacuum holders supplied by themanufacturer. Lower the glass to rest in a safe place to preventdamage to the glass edges. Extra care must be taken when remov-ing/installing the glass; breakage or damage to the edge of theglass which occurs as a result of careless handling is not coveredunder warranty.• We recommend handling the glass with supplied vacuum clamps• When removing glass, prepare a soft, scratch resistantsurface to place the 60-1/4"x 19-13/16" glass• Never clean or remove hot glassNote: The suction cups may leave a round film on the glass whenused. Ensure that the glass is cleaned using a fireplace glass cleanerafter each removal and prior to operating the appliance.Note: glass panels must be installed to operate fireplace4. Open the 8 clamps at the top of the glass.Handle glass with supplied vacuum clampsGlass supports in upright positionClamps in closed positionPress glass vacuum clamps in open position firmly onto surface of glass.Bring handles together to close.Open ClosedNote--the following installation diagrams do not include thevacuum clamps but it is strongly recommended to useclamps at all times when handling the firebox glass.Glass removal videoWith the top clamps in open position, use your hands to pull the two glassgasket rails towards you.Clamps in open position, rail pulledforwardCity Series CBV0E | 19owner's informationInner Glass Panel Installation / Removal1. Remove outer safety barrier glass panels if previously installed–see instruc -tions in this manual.2. Remove outer panels installed in unit - see panel removal section in this manual.3. From the front inside lower panel of the unit--pivot the glass support intoupright position as shown below.WARNING: GLASS HANDLINGWe recommend using the glass vacuum holders supplied by the manufac -turer. Lower the glass to rest in a safe place, this is to prevent damage to theglass edges. Extra care must be taken when removing/installing the glass.Breakage or damage to the edge of the glass which occurs as a result ofcareless handling will not be covered under warranty.• We recommend handling the glass with supplied vacuum clamps• When removing glass–prepare a soft, scratch resistantsurface to place the 60-3/8"x 18-1/4" glass• Never clean or remove hot glassNote: The suction cups may leave a round film on the glass whenused. Ensure that the glass is cleaned using a fireplace glasscleaner after each removal and prior to operating the appliance.Note: glass panels must be installed to operate fireplace4. Open the 8 clamps at the top of the glass.Handle glass with supplied vacuum clampsGlass supports in upright positionClamps in closed positionWith the top clamps in open position, use your hands to pull the two glassgasket rails towards you.Clamps in open position, rail pulledforwardPress glass vacuum clamps in open position firmly onto surface of glass.Bring handles together to close.Open ClosedNote--the following installation diagrams do not include the vacuumclamps but it is strongly recommended to use clamps atall times when handling the firebox glass.Glass removal video