43CUSTOMIZING YOUR KEYSETAME PASSWORDThis feature allows people using the AME feature to enable password protection.This will prevent unauthorized people from listening to your messages being left.The passcode is the same as your station passcode. This feature only applies ifthere is an SVMi card installed in the system and your keyset has a programmedAME button.• With the handset on-hook, press TRANSFER and then dial 110.• Dial 101 to turn on AME PASSCODE or 100 to turn it off.• Press TRANSFER to store your selection.AUTO CAMP-ONThis option allows intercom calls to be automatically camped on, if possible, whena busy station is called.• With the handset on-hook, press TRANSFER and then dial 110.• Press 081 to turn CAMP-ON on or 080 to turn it off.• Press TRANSFER to store your selection.SELECT RING TONEEach keyset user can select any one of eight ring frequencies:• While on-hook, press TRANSFER and then dial 111.• Dial 1–8 or press the UP and DOWN buttons to hear each tone.• When you hear the tone that you prefer, press TRANSFER to save it.NOTE: Specific lines or stations may be programmed to ring with a differenttone than what you have selected for your keyset.CHANGE YOUR PASSCODEFrom the factory, your station passcode is 1234.You can change your station pass-code whenever you desire.• While on-hook, press TRANSFER and then dial 101.• Dial your old passcode.• Dial a new passcode (must be four characters). You can use 0–9.• Redial the new passcode to verify. If successful, you will hear two beeps. Fourbeeps indicate an incorrect code. Reenter the code again.• Press TRANSFER to store the new passcode.OHVA BLOCKYour keyset can be programmed with an OHVA Block (BLOCK) button. Pressingthis button will prevent anyone from making an OHVA to you until you press thebutton again and cancel the blocking.OHVA REJECTYour keyset can be programmed with an OHVA Reject (REJECT) button. Pressingthis button while receiving an OHVA call will disconnect the voice announcingparty and return you to your original call.IN GROUP/OUT OF GROUPIf your keyset is assigned to a station ring group, you can remove your keyset fromthe group and then put it back in. While you are out of the group, you can receivecalls to your extension number but not calls to the group number. If you have anIN/OUT button with the group number assigned.• Press the IN/OUT button. It will light red when your keyset is in the group.• Press the IN/OUT button again to exit the group and turn the light off. Repeatas necessary.If you do not have an IN/OUT button:• Dial the IN/OUT access code number ________________, then the groupnumber, then 0 to exit the group or 1 to enter the group.NOTE: If the Hot Keypad feature has been turned off, you must first lift the hand-set or press SPEAKER button.The IN/OUT button can include an extender to indicate the specific group thatthis button will affect. This means that if you are in multiple groups, you can de-cide for which groups you will receive calls.42