182. While a call is ringing in, press the SCREEN button to display the programma-ble button screen. This will enable you to view and invoke any of the stationfeatures that you may wish.UNIVERSAL ANSWEROutside lines may be programmed to ring a general alerting device. To answercalls ringing this device, dial 67—OR—press the UA button. This device can oper-ate in any one of the six different ring plans.NOTE: If the Hot Keypad feature has been turned off, you must first lift the handsetor press the SPEAKER button before dialing.RECALL DIAL TONE• Press the NEW button to disconnect your existing call, wait for dial tone andthen make a new call on the same line.NOTE: If this button does not appear on your keyset, the FLASH button may beprogrammed to recall dial tone.SENDING A FLASHWhile on an outside call, press the FLASH button to send a flash to the telephonecompany. This is required for some custom calling features or CENTREX use.NOTE: Flash is not available on an ISDN circuit.BUSY LINE QUEUING WITH CALLBACKIf you receive a busy signal when you are selecting an outside line, this means thatthe line or group of lines is busy.• Press the CALLBACK button, if programmed, or dial 44, you will hear confir-mation tone.• Press the ANS/RLS or END button.• When the line becomes free, the system will call you back.• Lift the handset or press the SEND button to answer, wait for dial tone and dialthe telephone number or speed dial number again.NOTES:1. A callback will be canceled if not answered within 30 seconds. If you have seta callback, the cursor associated with the CALLBACK button will be solidblack.2. If the Hot Keypad feature has been turned off, you must first lift the handsetor press the SPEAKER button before dialing.CANCELING CALLBACKA callback will be canceled if not answered within 30 seconds. If you have set acallback, the cursor associated with the CALLBACK button, will be solid black.To cancel a callback:• Press the CALLBACK button, if programmed, or dial 44. The display will showthe callback details and an option to CLEAR the callback.• Press the CLEAR button, or press the HOLD button.This will cancel the last setcallback and display the next set callback, also with the option to CLEAR.Thisprocess is repeated until all callbacks are cleared from memory.NOTE: If the Hot Keypad feature is turned off, you must first lift the handset orpress the SPEAKER button before dialing.19