11• The [0]-[9] dial buttons are used to directly choose a menu, or sub menuoptions.• The [ENTER] button in the navigation button assembly is used when saving amodification.• The [MENU] button in the navigation button assembly is used to to displaythe IP Setup Main Menu.• The [END] button in the navigation button assembly is used when cancelingor editing the modification, or existing programming.• The [CANCEL] button in the navigation button assembly is used to go back tothe previous screen or to delete the last digit of a displayed option value.MENU STRUCTUREThe IP SETUP MENU is configured as follows:1. INFORMATION1. Version2. Network3. Load Option4. MAC Address(Note that Option 3 will be indicated only when setting the Manual IP)2. NETWORK1. Mode2. IP3. Netmask4. Gateway(Note that Option 2 will be indicated only when setting the Manual IP)3. LOAD & UPGRADE1. Load Option2. Upgrade Program3. Upgrade Bootrom4. Format4. SYSTEM1. Password (Unused)5. SERVER1. Server IP2. ID3. Password6. EXITITP-5012L SETUPINITIALIZING THE ITP-5012LInitially the ITP-5012L IP keyset will need to be setup to operate within the usersnetwork.The Setup Menu is also used to make changes to the keyset, in the eventthat the system information should change. The option chosen via scroll buttonwill be highlighted.The station numbers will be automatically set by the iDCS 100 Release 2, the iDCS500 Release 2, or the OfficeServ 7200 system once the necessary information hasbeen entered into the IP keyset. Enter ID and password of the server, as describedbelow to register the phone.See your system administrator for specific Network and Server addresses. Theaddresses necessary to set up the ITP-5012L are:• IP Address of Station• Network Gateway Address• IP Address of System’s MCP• User ID• PasswordAs soon as the ITP-5012L IP phone is connected to the power supply, press theMENU button and the LCD displays the SETUP OPTIONS SCREEN.IP SETUP MENUTo enter the IP SETUP MENU, press the MENUbutton as soon as the ITP-5012L IP phone is con-nected to the power supply. Unplug the powerfrom the ITP. Press and hold the MENU buttonwhile plugging in the power, then release theMENU button.Once the IP SETUP MENU is displayed, you can move to each menu in the Set Upby using the navigation buttons and [1]-[9] dial buttons of the ITP-5012L IPphone.• The UP and DOWN directions buttons in the navigation button assembly areused to move the highlighted bar up or down to the desired option.• The LEFT and RIGHT buttons in the navigation button assembly are used tomove the highlighted bar left or right, to the desired option, move to a submenu and if a menu is at the last line, that menu option will be executed.Setup (1/6)1.Information2.Network3.Load & Upgrade4.System5.Server6.Exit10