14SMT-i5210 SETUPINITIALIZING THE SMT-i5210Initially the SMT-i5210 IP keyset will need to be setup to operate within the usersnetwork. The Setup Menu is also used to make changes to the keyset, in the eventthat the system information should change. The option chosen will be highlight-ed.The station numbers will be automatically set by the OfficeServ 7000 Series sys-tems once the necessary information has been entered into the IP keyset. Enter IDand password of the server, as described below to register the phone.See your system administrator for specific Network and Server addresses. Theaddresses necessary to set up the SMT-i5210 are:• IP Address of Station• Network Gateway Address• IP Address of System’s main processor• User ID• PasswordSETUP MODETo get to the Setup Mode unplug the power cord from the SMT-i5210. Press andhold the button while you plug power back into the phone. Release the but-ton when you see Samsung in the display. If you have a PoE (Power over Ethernet)connection, the same procedure can be done by unplugging and plugging theEthernet cable into the phone while pressing and holding the button.When the phone reboot is complete, the LanguageMenu will display. Press the Yes soft button to advance tothe Configuration Menu.Once the Configuration Menu is displayed, you can move to each menu in theSetup by using the navigation button and [1]-[8] dial buttons of the SMT-i5210 IPphone. To learn how to navigate the menus refer to the previous section.15EASY INSTALL WIZARDBy selecting this option, the System Easy Wizard can guide you through setting upyour network parameters. If you want to set up these parameters individually, fol-low the instructions below.• From the idle phone press Menu, scroll to Phone, and press OK button. Scrollto Phone Information and press OK button. From the keypad, press [153#].Scroll to Easy Install and press OK button.SELECTING THE STATIC IP OPTION• When the Static IP option is selected, enter the System Type OSSP (KP), andpress OK.• Enter the Static IP Address for the phone (eg. 192.168.9.193) then press theOK button.• Enter the Subnet Mask (eg. 255.255.255.0); press OK button.• Enter Gateway Address (eg. 192.168.9.1), press OK button.NOTE: Press the key on the dial pad to enter the “.” in the IP address.• Skip [VLAN-PHONE], [VLAN-PC], [802.1x Setting] by pressing the OK buttonthree times.• Enter the System IP address (eg. 192.168.9.200), press OK button.• Enter System ID XXXX (eg. 3201), then press OK button.• Enter Password XXXX (eg. 1234) then press OK button.Wait a second for the phone to reboot. The phone should register and authenti-cate itself to the phone system. Test SMT-i5210 for proper operation.SETTING UP HOT DESKING [IDLE LOGIN]Hot Desking allows you to log in and out of your SMT-i5210 IP keyset withoutrebooting.• Press the Menu soft button, scroll to Phone then press OK button.• Scroll to Phone Information and press OK button.• Enter the administrator’s password (please contact your phone system admin-istrator).• Scroll to Extension Login then press OK button.• Choose the ON option and press OK button. (Note: On to allow, Off to denyhot desking).• Press the Save soft button to complete the setup.• When the phone restarts, enter the ID (eg; extension 2809) and password.• Press the Save soft button to complete the login.
