27LAST NUMBER REDIALTo redial the last telephone number you dialed, press the LNR key or dial 19.NOTES:1. If the Hot Keypad feature has been turned off, you must first lift the handset orpress SPK or MONITOR before you begin dialing.2. Redial does not apply to intercom calls.MANUAL RETRY WITH LNRWhile you are on an outside call listening to a busy signal and you want to redialthe same number dialed.• Press the LNR key.This will hang up your existing call and manually redial the same number dialed.You can repeat this operation for a limited number of attempts.SAVE NUMBER WITH REDIALTo save the number you just dialed for later use, press the SNR key before hangingup.To redial this saved number at any time, press the SNR key or dial 17.The same linewill be selected for you.NOTES:1. If the Hot Keypad feature has been turned off, you must first lift the handset orpress SPK or the MONITOR key if you are using a 7B phone before you begindialing.2. The saved telephone number is stored in memory until you save another.3. Redial does not apply to intercom calls.CHAIN DIALINGYou may manually dial additional digits following a speed dial number or chain asmany speed dial numbers together as required:• After the first speed number is dialed, press SPD again and dial another speednumber OR manually dial additional digits following a speed dial number.For the purposes of programming speed dial numbers, the programmable keys inthe bottom row are known as A, B, C, D, E and F and are defined below.• The A key is not used.• The B key inserts a flash.• The C key inserts a pause.• The D key is used for pulse to tone conversion. If your system uses rotary (orpulse) dialing C.O. lines, pressing D while entering a speed dial number causesall subsequent digits to be sent as DTMF tones.• The E key is used to hide digits. Display keyset users may want to hide somespeed dial numbers so that they will not show in the display.When you are en-tering a telephone number, press E. All subsequent digits will be hidden. PressE again to begin displaying digits.• The F key is used to enter a name. See Personal Speed Dial Names under DisplayFeatures.• Use the HOLD key to clear a speed dial number.ONE TOUCH SPEED DIALINGYou may assign any speed dial number to an already existing One Touch SpeedDial button for quick and easy dialing of frequently used numbers.• While on-hook, press TRSF and then dial 107.• Press a One Touch Speed Dial button.• Dial the speed dial number (00–49 or 500–999) that you want assigned to thisbutton.• Press TRSF to store your selection.To call this telephone number, just press the One Touch Speed Dial button.NOTE: If the Hot Keypad feature has been turned off, you must first lift the handsetor press SPK or the MONITOR key if you are using a 7B phone before you begindialing.26A B C D E F12 BUTTON KEYSETPROGRAMMABLE KEYS LAYOUTA B C D E F24 BUTTON KEYSETPROGRAMMABLE KEYS LAYOUT
