PLC-WM4500/WM4500L Expand Serial Command Functional Specifications21/788.4.11 CF_PROGV CommandCommand “CF_PROGV_%1” [CR]%1“ON” ----------------- Set Progressive scan to On.“FILM” --------------- Set Progressive scan to Film.“OFF” ---------------- Set Progressive scan to OFF.“UP” ------------------ Switch setting forward direction (OFF→ON→FILM→OFF)“DN” ------------------ Switch setting backward direction (OFF→FILM→ON→OFF)DetailsSet Progressive scan mode. (Available only in the normal Power ON status)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.4.12 CF_IMAGE CommandCommand “CF_IMAGE_%1” [CR]%1“DYNAMIC” ------ Dynamic (Fixed value to enable projection with a sharp,powerful picture tone)“STAND” ------ Standard(Image adjust value is set to factory default for Still Image)“REAL------------------ Real (Fixed value to display graphic image with natural tone)“NATURAL”------------- Natural (Fixed value to provide image with more naturalcolor and tone)“CINEMA”------------- Cinema (Fixed value to focus on tone reproduction for movie)“CUSTOM1” ------------- Image1 the value adjusted and stored by user“CUSTOM2” ------------- Image2 the value adjusted and stored by user“CUSTOM3” ------------- Image3 the value adjusted and stored by user“CUSTOM4” ------------- Image4 the value adjusted and stored by user“CUSTOM5” ------------- Image5 the value adjusted and stored by user“CUSTOM6” ------------- Image6 the value adjusted and stored by user“CUSTOM7” ------------- Image7 the value adjusted and stored by user“CUSTOM8” ------------- Image8 the value adjusted and stored by user“CUSTOM9” ------------- Image9 the value adjusted and stored by user“CUSTOM10” ----------- Image10 the value adjusted and stored by userDetailsSelect Image Mode (Available only in the normal Power ON status)Parameter “CUSTOM1” to “CUSTOM10” corresponds to “Image1” to “Image10”displayed in projector OSD menu on selecting Image.The value set by this command is stored in EEPROM so that the setting canremain effective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]