PLC-WM4500/WM4500L Expand Serial Command Functional Specifications42/788.10.19 CF_FILH CommandCommand “CF_FILH_%1” [CR]%1 “RST” ---------------------- Reset Filter used timeDetails Reset used time for filter of projectorAcceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.20 CF_FILTIMER CommandCommand “CF_FILTIMER_%1” [CR]%1“0600” ---------------------- Set 600 hours“0900” ---------------------- Set 900 hours“1200” ---------------------- Set 1200 hours“1500” ---------------------- Set 1500 hours“1800” ---------------------- Set 1800 hours“2000” ---------------------- Set 2000 hours“OFF” ---------------------- Set Off (Do not warning display)Details Set time to display Filter cleaning / replacement warning on screenAcceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.21 CF_FANSPEED CommandCommand “CF_FANSPEED_%1” [CR]%1 “MAX” ------------------------------ Select maximum fan speed“NOR” ------------------------------ Select normal fan speedDetailsSwitch Fan Control Speed mode.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.22 CF_SIMPLEMODE CommandCommand “CF_SIMPLEMODE_%1” [CR]%1 “ON” ------------------------------ Set Simple mode to ON“OFF” ----------------------------- Set Simple mode to OFFDetailsSet Simple mode.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]