Sanyo PLC-WM4500/L - 4500 Lumens Manual

Also see for PLC-WM4500: Owner's manual User manual Owner's manual Owner's manual Manual

Contents

PLC-WM4500/WM4500L Expand Serial Command Functional Specifications23/788.5 PC Adjust Control Command8.5.1 CF_FSYNC CommandCommand “CF_FSYNC_%1” [CR]%1“0000-0031” ----------------- Directly specify setting value of Fine Sync“UP” --------------------------- Increment setting value of Fine Sync by 1“DN” --------------------------- Decrement setting value of Fine Sync by 1DetailsSet value of Fine Sync in PC signal (Available only in the normal Power ONstatus)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting.Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal8.5.2 CF_TDOTS CommandCommand “CF_TDOTS_%1” [CR]%1“mmmm - nnnn” --------------- Directly specify setting value of Total Dots“mmmm” indicates minimum value, which is current (Display area H + Position H)value“nnnn” indicates maximum value, which is less than 140 MHz in Dot Clocks“UP” ------------------------- Increment setting value of Total Dots by 1“DN” ------------------------- Decrement setting value of Total Dots by 1DetailsSet value of Total Dots in PC signal (Available only in the normal Power ONstatus)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting.Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal8.5.3 CF_CLPPHASE CommandCommand “CF_CLPPHASE_%1” [CR]%1“0000-0255” ----------- Directly specify setting value of Clamp Phase“UP” --------------------- Increment setting value of Clamp Phase by 1“DN” --------------------- Decrement setting value of Clamp Phase by 1DetailsSet value of Clamp Phase (Available only in the normal Power ON status)The value set by this command will not be stored in the projector. Therefore, whenthe power is turned to ALL OFF, the value returns to the original setting.Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal