PLC-WM4500/WM4500L Expand Serial Command Functional Specifications38/788.10.6 CF_LOGO CommandCommand “CF_LOGO_%1_%2” [CR]%1 “0000 – 9999” ------------- Directly set Logo PIN code%2“OFF” ---------------------------Cancel Logo display“DFLT” ------------------------- Select Logo of Factory Default“USER” ------------------------ Select User“UP” ---------------------------- Select functions to choose forward(OFF → DFLT → USER → OFF → --)“DN” ---------------------------- Select functions to choose backward(OFF → USER → DFLT → OFF → --)DetailsSet Logo mode.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting remainseffective even after the power is turned to ALL OFF status.Set Logo PIN code in %1.When Logo Lock is enabled:PIN code is matched ------------------------- Command is valid (Acceptable)PIN code is mismatched-------------------- Command is invalid (Error code “102”)PIN code is beyond %1 available range -------Command is invalid (Error code”?”)When Logo Lock is disabled:PIN code is within %1 available range ------- Command is valid (Acceptable)PIN code is out of %1 available range ------- Command is invalid (Error code “?”)Note: When Logo Lock is enabled, matching Logo PIN code switches Logo butLogo Lock is not cancelled (Lock status is kept).*When 2=”USER” is received, error code “101” is returned, in the case ofCapture non-practice.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.7 CF_PIP CommandCommand “CF_PIP_%1” [CR]%1“OFF” -------------------- Select Off“USER1” ---------------- Select User1“USER2” ---------------- Select User2“USER3” ---------------- Select User3“USER4” ---------------- Select User4“USER5” ---------------- Select User5DetailsSet ”Picture in Picture” status.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and the setting remainseven after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.8 CF_PIPMODE CommandCommand “CF_PIPMODE_%1” [CR]%1 “PINP” -------------------- Select P in P mode“PBYP” ------------------- Select P by P modeDetails Set mode in “Picture in Picture”. (Available only in the normal Power ON status)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]