PLC-WM4500/WM4500L Expand Serial Command Functional Specifications46/788.10.34 CF_PJPINCODE CommandCommand “CF_PJPINCODE_%1” [CR]%1 “0000 – 9999” ------------- Directly specify PJ PIN codeDetailsEnter PIN code to cancel PIN code lock (Available only in the normal Power ONstatus)PIN code can not be changed. (Only PIN code lock is canceled.)*When PIN code Lock is enabled:PIN code is matched ------------------------- Command is valid (Acceptable)PIN code is mismatched -------------------- Command is invalid (Error code “102”)PIN code is beyond %1 available range ---- Command is invalid (Error code “?”)*When PIN code lock is canceled:PIN code is within %1 range ----------- Command is valid (Acceptable)PIN code is out of %1 range ----------- Command is invalid (Error code is 102)This command is only valid when “PJ PIN code” dialog is displayed to enter PINcode after Power is ON and Countdown is completed.When PIN code lock is set to “On1”, it needs to send this command every timethe projector is turned on.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.35 CF_CCAPTIONDISP CommandCommand “CF_CCAPTIONDISP_%1”[CR]%1“OFF” ------------- Select Off“CC1” ------------- Select CC1“CC2” ------------- Select CC2“CC3” ------------- Select CC3“CC4” ------------- Select CC4DetailsSelect channel of Closed caption.The status set with this command is stored in EEPROM and its setting is effectiveeven after ALL is OFF.This command is available in normal Power ON status.Note)Closed caption is available under conditions below;Entered signal is appropriate (Video, NTSC signal of S-video, Component=480i)and System is fixed to NTSC or 480i.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]8.10.36 CF_CCAPTIONCOLOR CommandCommand “CF_CCAPTIONCOLOR_%1”[CR]%1 “COLOR” ------- Select Color“WHITE” -------- Select WhiteDetailsSelect color of Closed caption.The status set with this command is stored in EEPROM and its setting is effectiveeven after ALL is OFF.This command is available in normal Power ON status.Note)Closed caption is available under conditions below;Entered signal is appropriate (Video, NTSC signal of S-video) and System is fixedto NTSC.Acceptable “000”[CR]ResponseUnacceptable “Error Code”[CR]