PLC-WM4500/WM4500L Expand Serial Command Functional Specifications24/788.5.4 CF_H-POS CommandCommand “CF_H-POS_%1” [CR]%1“0000-nnnn” -------- Directly specify setting value of Horizontal Position“nnnn” indicates maximum value, which is current value of (Total dots - Display area H)“UP” ------------------- Increment setting value of Horizontal Position by 1“DN” ------------------ Decrement setting value of Horizontal Position by 1DetailsSet value of Horizontal Position in PC signal (Available only in the normal PowerON status)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting.Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal8.5.5 CF_V-POS CommandCommand “CF_V-POS_%1” [CR]%1“0000-nnnn” ------------ Directly specify setting value of Vertical Position“nnnn” indicates maximum value, which is current (Total Line – Display Area V) value“UP” --------------------- Increment setting value of Vertical Position by 1“DN” --------------------- Decrement setting value of Vertical Position by 1DetailsSet Vertical Position value (Available only in the normal Power ON status)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting.Acceptable “000” [CR]ResponseUnacceptable “101” [CR] ---- When input is Video signal--- When input is no signal8.5.6 CF_DDOTS CommandCommand “CF_DDOTS_%1” [CR]%1“0100-nnnn” -------------- Directly specify setting value of Display Dots“nnnn” indicates maximum value, which is current value of (Total Dots - Position H).In this projector, the value should be “even number” and if “odd number” is specified, itadds 1 to make the value even number.“UP” ------------------------ Increment setting value of Display Dots by 2“DN” ------------------------ Decrement setting value of Display Dots by 2DetailsSet setting value of Display Dots in PC signal (Available only in the normalPower ON status)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting.Acceptable “000” [CR]ResponseUnacceptable “101” [CR] --- When input is Video signal--- When input is no signal