PLC-WM4500/WM4500L Expand Serial Command Functional Specifications45/788.10.30 CF_PTIMEMODE CommandCommand “CF_PTIMEMODE_%1” [CR]%1 “COUNTUP” ---------------------- Set P-timer to Count up mode“COUNTDN” ---------------------- Set P-timer to Count down modeDetailsSelect count up/down mode of P-timer.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting value remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.31 CF_PTIMER CommandCommand “CF_PTIMER_%1” [CR]%1“START” -------------------------- Start P-timer“STOP” ---------------------------- Stop P-timer“RESTART” ---------------------- Resume P-timer“RST” ------------------------------ Reset P-timer“EXIT” ----------------------------- Exit P-timer functionDetails Select the status of P-timer.(Available only in the normal Power ON status)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.32 CF_PTIME CommandCommand “CF_PTIME_%1” [CR]%1 “001” – “180” -------------------------- Directly specify setting timeDetailsSet the time for Count down mode of P-timer.(Available only in the normal Power ON status)The status set by this command is stored in EEPROM and setting value remainseffective even after the power is turned to ALL OFF status.Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.10.33 CF_KEYDIS CommandCommand “CF_KEYDIS_%1” [CR]%1“NONE” ----------------------- RC and KEY are both enabled.“RC” ---------------------------- RC is disabled.“KEY” -------------------------- KEY is disabled.Details Disable RC and/or KEY functions(Available only in the normal Power ON status)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]