Tascam Digital Portastudio DP-03 Owner's Manual

Also see for Digital Portastudio DP-03: Manual

Contents

Tascam Digital Portastudio DP-03 Owner's Manual Manual pdf 3 page image

TASCAM DP-03 3CAUTIONS ABOUT LASER RADIATIONªThis product has been designed and manufacturedaccording to FDA regulations “title 21, CFR, chapter 1,subchapter J, based on the Radiation Control for Healthand Safety Act of 1968,” and is classified as a class 1 laserproduct. There is no hazardous invisible laser radiationduring operation because invisible laser radiation emittedinside of this product is completely confined in theprotective housings.The label required in this regulation is shown at 1.Cautions:DO NOT REMOVE THE PROTECTIVE HOUSING USING A•SCREWDRIVER.USE OF CONTROLS OR ADJUSTMENTS OR•PERFORMANCE OF PROCEDURES OTHER THAN THOSESPECIFIED HEREIN MAY RESULT IN HAZARDOUSRADIATION EXPOSURE.IF THIS PRODUCT DEVELOPS TROUBLE, CONTACT YOUR•NEAREST QUALIFIED SERVICE PERSONNEL, AND DONOT USE THE PRODUCT IN ITS DAMAGED STATE.Optical pickupType : SF-DS29IManufacturer : SANYO Electric Co., Ltd.Laser output : Less than 49.1 mW on the objective lensWavelength : 785 nm (Typ.)Standard : IEC60825-1: 2001For U.S.A.ªTO THE USERThis equipment has been tested and found to complywith the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference ina residential installation. This equipment generates,uses, and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructionmanual, may cause harmful interference to radiocommunications. However, there is no guarantee thatinterference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radioor television reception, which can be determined byturning the equipment off and on, the user is encouragedto try to correct the interference by one or more of thefollowing measures.a) Reorient or relocate the receiving antenna.b) Increase the separation between the equipment andreceiver.c) Connect the equipment into an outlet on a circuitdifferent from that to which the receiver is connected.d) Consult the dealer or an experienced radio/TVtechnician for help.CAUTIONChanges or modifications to this equipment not expresslyapproved by TEAC CORPORATION for compliance couldvoid the user's authority to operate this equipment.For European CustomersªDisposal of electrical and electronic equipment(a) All electrical and electronic equipment should bedisposed of separately from the municipal wastestream via collection facilities designated by thegovernment or local authorities.(b) By disposing of electrical and electronic equipmentcorrectly, you will help save valuable resources andprevent any potential negative effects on humanhealth and the environment.(c) Improper disposal of waste electrical and electronicequipment can have serious effects on theenvironment and human health because of thepresence of hazardous substances in the equipment.(d) The Waste Electrical and Electronic Equipment (WEEE)symbol, which shows a wheeled bin that has beencrossed out, indicates that electrical and electronicequipment must be collected and disposed ofseparately from household waste.(e) Return and collection systems are available to endusers. For more detailed information about thedisposal of old electrical and electronic equipment,please contact your city office, waste disposal serviceor the shop where you purchased the equipment.IMPORTANT SAFETY INSTRUCTIONS