Walker H37i Operator's Manual

Also see for H37i: Operator's manual Operator's manual Operator's manual

Operating Instructions42ADJUSTABLE FOOT RESTSSome carrier frames are outfitted with adjustablefoot rests. To adjust, rotate the footrests upward andslide to the desired position. Rotate the footrestdown and insert the edge of the footrest into thenearest notch to lock in position.Adjustable FootrestADJUSTING CUTTING HEIGHTWARNINGNever adjust cutting height while the mow-er is moving. Before adjusting cuttingheight or servicing, move the ForwardSpeed Control (FSC) into the NEUTRAL-PARK position, engage the parking brake,and disengage the blade clutch (PTO).Tractor should not be moving while adjust-ing cutting height.Cutting height is adjusted from operator’s seat usingthe deck lift pedal to assist in raising the deck whileadjusting the cutting height hitch pin.1. Disengage PTO and stop tractor.2. Push down on deck lift pedal until it latches inthe full up (transport) position.3. Select the desired cutting height by moving thehitch pin to the location shown on the cuttingheight decal.4. Push down on the lift pedal and lift up on thecutting height release lever. Slowly release thepedal while lifting the lever until the deck is inthe selected cutting height position.Deck Lift PedalCutting HeightRelease LeverHeightAdjustment DecalHitch PinCutting Height AdjustmentPush DeckLift PedalRaise ReleaseLeverLowering Deck to Selected Cutting HeightTransport Position1. Disengage the PTO.2. Push down on deck lift pedal until it latches inthe full up (transport) position.TRANSAXLE LOCKOUTIMPORTANT: DO NOT TOW this mower faster than2 mph (3.2 km/h) with the transaxle lockout engaged. Towing can produce excessive internalpressure and damage the transaxle(s).To move the mower with the engine NOT running(dead battery, maintenance, etc.), the transaxlesneed to be unlocked (released).