8825/8830 DDS User Guide/85ReferenceScanner Diagnostics (continued)Full System TestThe FULL SYSTEM TEST checks the control electronics in the Scanner.To test the control electronics, select FULL SYSTEM TEST from theSCANNER DIAGNOSTICS MENU.The FULL SYSTEM TEST screen is displayed.Each letter corresponds to a test, identified in the table to the right.While a subtest is in progress, an R is displayed to the right of the test letter.If the subtest is successful, a P is displayedIf a subtest fails, an F will be displayed. If an F is displayed, call for service.Note: the test sequence will be executed until the operator presses the Exitkey, or until all subtests are completed.The Memory Tests (J) are the same tests as those executed whenMEMORY TESTS is selected from the SCANNER DIAGNOSTICS menu. Inthis case, a global pass or fail result is reported. If you wish an explicit reporton each memory test, use the MEMORY TESTS selection instead of theFULL SYSTEM TEST selection.FULL SYSTEM TESTA) B) C) D) E) F)G) H) I) J) K)PRESS START TO BEGIN
