FaxingPhaser 6121MFP Multifunction PrinterUser Guide118Sending a Fax from the Auto Document Feeder1. Remove any staples or paper clips from the pages and insert the pages faceup with the top of thepages entering the feeder first. Adjust the paper guides so they fit against the originals as shown:Note: Do not load more than 35 pages into the auto document feeder.2. On the printer control panel, press the Fax button.3. The menu displays “Fax To.” Press the OK button and then use the alphanumeric keypad to enterthe fax telephone number. Press OK.Note: If the fax number requires a pause, press the Redial/Pause button to insert a 2.5-secondpause where needed. The pause entered displays as a “P” in the fax number you see in the menu.4. Press the Down Arrow button to go to Finish and then press OK, then press the Start/B&W button.Note: Depending on your default fax settings, the printer either first scans the pages, dials, andwaits for a connection before sending the fax, or the printer dials, waits for a connection, and thenscans the pages. The printer then transmits the fax. The fax transmission status is printed on theconfirmation page that prints after the fax is sent. To change fax send default options, seeChanging the Default Fax Send Options on page 123.Sending a Fax Manually Using the On Hook ButtonWhen sending a fax internationally, you may need to listen in as the fax connection goes throughvarious exchanges before connecting to the destination number. In that case, you can send the faxmanually so that when you finally hear the fax tone, you can start the fax transmission.To send a fax manually using the On Hook button:1. Load the document into the auto document feeder.Note: When sending a fax manually using the On Hook feature, you must load the document intothe auto document feeder instead of placing the document on the document glass or else an errorwill occur.2. If desired, adjust the image quality. See Selecting Fax Options for Single Jobs on page 123.3. On the printer control panel, press the On Hook button.4. At the printer control panel, do one of the following to enter a fax number:• Use the alphanumeric keypad to enter the fax number and then press the Start/B&W button.• Press the Address Book button and then, when prompted, enter a Speed Dial number. Confirmthat the recipient displayed is the one you want and then press the OK button.• Press the Redial/Pause button to use the number of the last recipient dialed.6121-078
