Installation and SetupPhaser 6121MFP Multifunction PrinterUser Guide34Phaser 6121MFP/D Printer Configuration with OptionsThe image below shows the printer configuration with all available options including the second trayand the duplex unit.3. After positioning the printer, you are ready to connect it to the power source and computer. Go tothe next section, Connecting the Printer on page 34.Connecting the PrinterNote: Connect the printer via Ethernet or USB. A USB connection is a direct connection and is notused for networking. An Ethernet connection is used for networking. An Ethernet connection isfaster than a USB connection. Hardware and cabling requirements vary for the differentconnection methods. Cabling and hardware are generally not included with your printer and mustbe purchased separately.1. Attach the cables:• If you have a Phaser 6121MFP/S printer configuration, you will connect the printer to yourcomputer via a standard A/B USB 2.0 cable.• If you have a Phaser 6121MFP/N or /D printer configuration and your computer is connectedto a network, connect the printer to the network using a standard Ethernet cable (category 5,RJ45). If you do not have a network, connect the printer to your computer using a standard A/BUSB 2.0 cable.2. If you have a Phaser 6121MFP/N or /D printer configuration and plan to use the fax feature,connect the printer to a phone line for sending and receiving faxes. For safety information, seeTelephone Line Cord on page 11.3. Attach the power cord and then plug in the printer and turn it on. For safety information, see PowerCord on page 10.4. (USB connections only.) If the Found New Hardware Wizard appears on your computer screenafter you plug in the printer, click the Cancel button.5. Go to Initial Setup at the Control Panel on page 35.814 mm (32.0")794 mm(31.3")100 mm (3.9")154 mm (6.1")116 mm (4.6")714 mm (28.1")560 mm (22.0")
