Installation and SetupPhaser 6121MFP Multifunction PrinterUser Guide35Initial Setup at the Control PanelThis section includes:• Configuring the Phaser 6121MFP/S on page 35• Configuring the Phaser 6121MFP/N or /D on page 35• Accessing the General Setup Menu on page 36• Assigning the Printer’s Network Address on page 36The first time you turn the printer on, the Initial Setup menu on the printer control panel prompts youto select your language. If you have a Phaser 6121MFP/N or /D printer configuration, you will also beprompted to configure regional fax settings.Configuring the Phaser 6121MFP/SNote: These instructions are for setting up the Phaser 6121MFP/S printer configuration. If you arenot sure what type of printer configuration you have, see What Type of Printer Do I Have? onpage 30.To configure the Phaser 6121MFP/S:1. After the printer is turned on for the first time, you are prompted to select the language. On theprinter control panel, use the Down Arrow button to select your language and then press the OKbutton.2. Use the keypad buttons to enter the date and the time in the format shown in the menu.3. Press OK.4. Select the units of measurement you want the printer to use when enlarging or reducing images:• Inch• Metric5. Press OK.You are done with the initial setup. Continue to Installing the Software on page 38.Configuring the Phaser 6121MFP/N or /DNote: These instructions are for setting up Phaser 6121MFP/N or /D printer configurations. If youare not sure what type of printer configuration you have, see What Type of Printer Do I Have? onpage 30.To configure a Phaser 6121MFP/N or /D:1. After the printer is turned on for the first time, you are prompted to select the language and faxsettings. On the printer control panel, use the Down Arrow button to select your language andthen press the OK button.2. Arrow down to your country and press OK.
