3-22 Phaser 6130 Color Laser Printer Service ManualError Messages and CodesOut of MemoryThe printer memory is full and cannot continue to print. Print job requiresadditional memory.Applicable Chain Link■ Chain Link 016-718: Out of memoryInitial Actions■ Cycle printer power.■ If the problem persists, follow the procedure below.4 Reseat plugs and jacks on the ImageProcessor Board (refer to theprocedure on page 8-60).Does the error still occur when thepower is turned OFF and ON?Go to step 4. Complete5 Re-download the correct file for6130N from the Xerox web site.Does the error still occur when thepower is turned OFF and ON?Replace theImageProcessor Board(page 8-60).CompleteTroubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ Image Processor Board, PL8.1.9■ Memory Card (Option)“Map 3 - LVPS, Drive Motors, I/P Board, ACPower” on page 10-10“Controller” on page 10-31Troubleshooting Procedure TableStep Actions and Questions Yes No1 1. Check the required memory for theprint job.2. Print a small size file (like aWindows test print).3. Does the error still occur?Go to step 2. Add memorycard or separatethe print job.2 Reseat the memory card. Does theerror still occur?Go to step 3. Complete.Troubleshooting Procedure (continued)Step Actions and Questions Yes No
