Phaser 6130 Color Laser Printer Service Manual 3-63Error Messages and CodesReplace Fuser / Fuser LifeThe Fuser has reached end of life.Applicable Chain Link■ 010-351: The Fuser is at end of life.5 Check the resistances of Temp. Sensorin the FuserRemove the Fuser.Warning: Start the operation after theFuser has cooled down.Check the resistances across thefollowing pins of the removed Fuser.J171-5 <=> J171-4J171-6 <=> J171-8J171-6 <=> J171-7Can the resistances be measured?(The resistances are 7 k-ohm at 180degrees C).Replace theMCU Board(page 8-59)Replace theFuser(page 8-9).After replacingthe Fuser, besure to reset thelife countervalue.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map ReferencesFuser (PL6.1.1)MCU Board (PL8.2.13)■ “Map 2 - Laser Unit, Feeder Assembly”on page 10-9■ “Map 4 - Toner Dispenser Motors, HVPS,MCU” on page 10-11■ “Feeder, Manual Feed, & Registration” onpage 10-19Troubleshooting Procedure TableStep Actions and Questions Yes No1 Check the life counter value of theFuserDoes the life counter value show thenear of the end?Replace theFuser(page 8-9).After replacingthe Fuser, besure to reset thelife countervalue.Go to step 2.Troubleshooting Procedure Table (continued)Step Actions and Questions Yes No
