3-34 Phaser 6130 Color Laser Printer Service ManualError Messages and CodesJam at Front CoverPaper fed from Paper Tray arrived at or left the Registration Sensor early.Initial Actions■ Check the paper path for obstructions or debris.■ Cycle printer power.■ If the problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map References■ Drive Clutch Assy Kit (PL3.1.99)■ Left Side Harness Assy (PL3.1.18)■ Feeder Assy NV (PL3.1.3)■ Photo Sensor (PL3.2.13)■ MCU Board (PL8.2.13)■ “Map 2 - Laser Unit, Feeder Assembly”on page 10-9■ “Map 4 - Toner Dispenser Motors, HVPS,MCU” on page 10-11■ “Feeder, Manual Feed, & Registration” onpage 10-19Troubleshooting Procedure TableStep Actions and Questions Yes No1 Check the paper settingWas the paper setting for the Traycorrect?Go to step 3. Enter the correctpaper setting,then go to step2.2 Does the error still occur whenprinting?Go to step 3. Complete.3 Using your finger, check theRegistration Roller and MetalRegistration Roller for contactDoes the spring force on both sides ofthe Metal Registration Roller hold itfirmly in contact with the RegistrationRoller?Go to step 4. Replace theFeeder Assy NV(page 8-25).4 Perform the Regi Clutch test(page 4-33): Service Mode > EngineDiag > Motor Test > Regi Clutch.Does the Regi Clutch operateproperly?Go to step 5. Go to step 6.
