Phaser 6130 Color Laser Printer Service Manual 6-3Adjustments and CalibrationsEnabling/Disabling Automatic Color RegistrationThis procedure provides instructions for how to enable or disable theAutomatic Color Registration function after a new Imaging Unit is installed.■ If the function is set to On, the printer will calibrate the color alignmentevery time it detects a new Imaging Unit.■ If the function is set to Off, calibration will not occur. This allows users tosave toner.To enable or disable the Automatic Color Registration:1. From the Control Panel, press the Menu button.2. Press the Up Arrow or Down Arrow button to find Admin Menu. Pressthe OK button.3. Press the Up Arrow or Down Arrow button to find Maintenance Mode.Press the OK button.4. Press the Up Arrow or Down Arrow button find Adjust Regi. Press theOK button.5. Press the Up Arrow or Down Arrow button to turn automatic colorregistration On or Off.Adjusting Color RegistrationColor Registration can be automatically or manually adjusted.Determining the ValuesFrom the lines to the right of the Y (yellow), M (magenta), and C (cyan)pattern, find the values of the straightest lines.When “0” is the value nearest the straightest line, you do not need to adjustthe color registration. When the value is not “0,” refer to “Manual ColorRegistration Adjustment” on page 6-4.Auto Adjustment1. From the Control Panel, press the Menu button.2. Press the Up Arrow or Down Arrow button to find Admin Menu. Pressthe OK button.3. Press the Up Arrow or Down Arrow button to find Maintenance Mode.Press the OK button.4. Press the Up Arrow or Down Arrow button find Adjust Color Regi.Press the OK button.5. The Auto Adjust menu is displayed. Press the OK button.6. Are you sure? message is displayed. Press the OK button to start theAuto Adjustment procedure.7. The printer starts the auto Color Registration process.8. When the auto Color Registration is completed, the Ready menu isdisplayed.
