3-64 Phaser 6130 Color Laser Printer Service ManualError Messages and CodesFuser ErrorApplicable Chain Link■ 010-397: Fuser failure is detected.2 Check after reseating the FuserReseat the Fuser.Warning: Start the operation after theFuser has cooled down.Does the error still occur when thepower is turned OFF and ON?Go to step 3. Complete3 Check after replacing the FuserReplace the Fuser (page 8-9).Warning: Start the operation after theFuser has cooled down.Does the error still occur when thepower is turned OFF and ON?NOTE: After replacement, be sure toclear the life counter value.Replace theMCU Board(page 8-59).CompleteTroubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map ReferencesFuser (PL6.1.1)LVPS Board (PL8.2.1)MCU Board (PL8.2.13)■ “Map 1 - Transfer Unit, Control Panel,Imaging Unit, Dispenser, Fuser” onpage 10-8■ “Map 3 - LVPS, Drive Motors, I/P Board,AC Power” on page 10-10■ “Map 4 - Toner Dispenser Motors, HVPS,MCU” on page 10-11■ “Fuser” on page 10-29Troubleshooting Procedure TableStep Actions and Questions Yes No1 Does the error still occur when thepower is turned OFF and ON?Go to step 2. Complete2 Check after reseating the FuserReseat the Fuser.Warning: Start the operation after theFuser has cooled down.Does the error still occur when thepower is turned OFF and ON?Go to step 3. CompleteTroubleshooting Procedure Table (continued)Step Actions and Questions Yes No
