Phaser 6130 Color Laser Printer Service Manual 3-37Error Messages and CodesJam at Manual Feed SlotPaper fed from the Manual Feed Slot did not reach the Registration Sensor ontime.Initial Actions■ Try picking paper from the tray.■ Check the paper path for obstructions or debris.■ Cycle printer power.■ If the problem persists, follow the procedure below.Troubleshooting Reference TableApplicable Parts Wiring and Plug/Jack Map Reference■ Drive Clutch Assy Kit, PL3.1.99■ Left Side Harness Assy, PL3.1.18■ Photo Sensor, PL3.2.13■ Actuator SSI, PL3.2.14■ Main Drive Assy, PL7.1.2■ MCU Board, PL8.2.13■ “Map 2 - Laser Unit, Feeder Assembly”on page 10-9■ “Map 4 - Toner Dispenser Motors, HVPS,MCU” on page 10-11■ “Feeder, Manual Feed, & Registration” onpage 10-19Troubleshooting Procedure TableStep Actions and Questions Yes No1 Check the paper sizeDoes the paper size meet thespecification?Go to step 3. Use the paperthat meets thespecifications,then go to step2.2 Does the error still occur whenprinting?Go to step 3. Complete3 Check the paper conditionIs the paper in the Manual Feed Slotwrinkled or damaged?Replace with anew and drysheet, then go tostep 4.Go to step 5.4 Does the error still occur whenprinting?Go to step 6. Complete5 Insert a fresh sheet of paper in theManual Feed Slot.Does the error still occur whenprinting?Go to step 6. Complete
