16. Introduction to the Command WorkStationXerox Phaser 79016–24Job commandsJob commands are used to assign a selected job to a new destinationor process. These commands are available from the Job menu. Manyare also available as right-mouse commands (described following thelist of commands below). The job commands available at a given timedepend on the context; unavailable commands are dimmed. Jobcommands are available in the Queues and Archive windows.How job commands affect raster dataThe job commands available for selected jobs in the Queues andArchive windows are listed in the following table. The table alsodescribes the effect of each command on raster data associated withthe job(s).Select To do Raster data is…Delete Delete the job(s). DeletedDuplicate Duplicate one or more selected PostScript,PCL, or PDF data jobs in the Spool or Printareas. You can use the duplicate job(s) fordifferent print options or a differentdestination. (The Duplicate commandactually creates a reference to the originaljob, with the same name).n/a(The Duplicate commandis not available for rasterjobs.)Rename Rename the job (PostScript, PCL, or PDF filewith or without raster).Unaffected, but associatedwith the new nameHold Hold the job in the current place (except for ajob in the Print area, which is moved to theSpool or RIP area, depending on whether itstill has raster data associated with it).Held in RIP area, ifincluded with jobRIP and Hold RIP the job and hold it in the RIP area. Held in RIP areaindefinitelyPrint Print the job in its turn (RIP it first if it doesnot have raster data).After printing, keep the printed job in the Printarea until the job limit is reached.Temporarily held in RAMafter printing until memoryis needed for another job.(If the job was printed froma held job in the RIP area,the raster data in the RIParea is kept indefinitely.)
