21. Performing the setup from WebSetupXerox Phaser 79021–8Network SetupNetwork Setup configures the printer to receive print jobs over thenetworks that are used at your site. If the printer is configured toenable more than one protocol, it automatically switches to the correctprotocol when it receives a print job. When the parallel port and one ortwo network ports are enabled, print jobs can be received over all portsat the same time.You can view and specify the following network settings in NetworkSetup:Adapters and ports—View currently configured network adapters andport settings.From local Setup only, the installed network boards are displayed.You cannot change this information. From remote Setup, you canenable Ethernet or Token Ring. You can also enable the parallelport, regardless of the network type you use.Protocols—including AppleTalk, IPX/SPX and TCP/IP.Print Services—including LPD printing (TCP/IP), NetWare printing(PServer), Windows print sharing (SMB), HTTP support (WWW),and Port 9100 printing.Once you enter IP addresses, the server will store them, even if youlater disable TCP/IP. If you need to assign the printer IP address toanother drive, set the address to a null address.In Network Setup, you can specify settings on the following tabs: Port,Protocol1, Protocol2, Service1, and Service2.
