Adjusting the color 23. Problem SolvingXerox Phaser 790 23-2911. BEST PATCH (ROW) is displayed on the Printer Control Panel. Use theup and down arrow buttons to enter the number of the row thatcorresponds to your circled selection.12. Press the Item/Enter button and perform one of the following steps:• If you enter any number other than 0, BEST PATCH (COL) appearson the Control Panel.a. Use the up and down arrow buttons to select the letter orname of the column that corresponds to your circled selection.b. Press the Item/Enter button. PRINTING GRAY BALANCEPAGE is displayed, and after a moment the page is deliveredthe Printer Output Tray.c. Select the color patch that is most like the gray, and performsteps 2 and 3 again.• If you enter 0, PRINT COLOR TEST YES appears on the ControlPanel.a. Press the Item/Enter button and, after a moment, theComparison Page is delivered to the output tray.b. Go to part 3 Comparison Page.3. Comparison PageThe Comparison Page allows you to see the changes you that made duringthe VisualCal adjustment. On the page are four rows of color photographs.The first row and the third row show the color setup before you selectedVisualCal. Row two and row four show the color setup after the VisualCaladjustment was completed. Now you must decide which setup is preferred.Perform one of the following steps:• If you are satisfied with your adjustments press the Item/Enter button.VISUALCAL appears on the Control Panel.The system saves your changes and after a moment READY isdisplayed.• If you are not satisfied with your adjustments, press the down arrowbutton and ensure that “No” is displayed on the Control Panel.a. Press the Item/Enter button. APPLY CHANGES DEFAULTCOLOR appears on the Control Panel.b. Press the Item/Enter button again. The system erases youradjustments and returns to the color default settings. After amoment READY is displayed.
