Power Saver modes are enabled on your device to reduce energy consumption. After the last print, thedevice transitions to Ready mode. In this mode, the device can print again immediately. If the deviceis not used for a specified period, the device transitions to Low Power mode, then to Sleep mode. Inthese modes, to enable reduced-power consumption, only essential functions remain active. The devicetakes longer to produce the first print after it exits the Power Saver modes than it takes to print in Readymode. This delay is the result of the system waking up and is typical of most imaging devices on themarket.To save power, you can enable Auto Power Off mode on your device. If Auto Power Off mode is enabled,you can configure the mode as follows:• Always Allowed: The device powers off automatically after the specified time, and the cumulativeLow Power mode and Sleep mode timeouts have elapsed.• Allowed ONLY When Conditions are Met: The device automatically powers off only after timeoutshave elapsed. The device also powers off if Fax, USB Drive, and Wired and Non-Wired Network havenot been activated.To change the Power Saver settings, refer to the User Guide atwww.xerox.com/office/VLB605_VLB615docs. For further assistance, contact your System Administratoror refer to the System Administrator Guide.To enable Auto Power Off mode, contact your System Administrator. For details, refer to the SystemAdministrator Guide at www.xerox.com/office/VLB605_VLB615docs.To learn more about Xerox participation in sustainability initiatives, go to:www.xerox.com/about-xerox/environment/enus.html.NoteChanging the default Power Saver activation times can result in an overall higher energy consumptionof the device. Before you turn off Power Saver modes or set a long activation time, consider the increasein device power consumption.Default Power Saver SettingsThis device is ENERGY STAR®-qualified under the ENERGY STAR Program Requirements for ImagingEquipment. The transition time from Ready mode to Low-Power mode can be set up to 60 minutes. Thedefault value is 5 minutes. The transition time from Low-Power mode to Sleep mode can be set up to60 minutes. The default value is set at 1 minute. The total transition time from Ready mode to Sleepmode can take up to 60 minutes.To change the Power Saver settings, contact your System Administrator, or refer to the SystemAdministrator Guide at www.xerox.com/office/VLB605_VLB615docs.Xerox® VersaLink® B605/B615 Multifunction PrinterB-2User GuideRegulatory Information
