Pan-European Analog PSTN andCompatible PBX CertificationsSpainLithuaniaFinlandSwedenLuxembourgFranceUnited KingdomMaltaGermanyIf you have problems with your product, contact your local Xerox representative. This product can beconfigured to be compatible with other country networks. Before reconnecting the device to a networkin another country, contact your Xerox representative for assistance.Note• Although this product can use either loop disconnect (pulse) or DTMF tone signaling, Xeroxrecommends that you use DTMF signaling. DTMF signaling provides reliable and faster call setup.• Modification of this product, or connection to external control software or control apparatus notauthorized by Xerox, invalidates its certification.New Zealand1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom hasaccepted that the item complies with minimum conditions for connection to its network. It indicatesno endorsement of the product by Telecom, it does not provide any sort of warranty, and it doesnot imply that any Telepermitted product is compatible with all Telecom network services. Aboveall, it provides no assurance that any item will work correctly in all respects with another item ofTelepermitted equipment of a different make or model.The equipment may not be capable of correct operation at the higher data speeds designated.33.6kbps and 56kbps connections are likely to be restricted to lower bit rates when connected tosome PSTN implementations. Telecom will accept no responsibility for difficulties that arise in suchcircumstances.2. Immediately disconnect this equipment should it become physically damaged, then arrange for itsdisposal or repair.3. This modem shall not be used in any manner which could constitute a nuisance to other Telecomcustomers.4. This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. Thereis no guarantee that Telecom lines will always continue to support pulse dialing.5. Use of pulse dialing, when this equipment is connected to the same line as other equipment, maygive rise to 'bell tinkle' or noise and cause a false answer condition. If you encounter such problems,do not contact the Telecom Faults Service.6. DTMF tones dialing is the preferred method because it is faster than pulse (decadic) dialing and isreadily available on almost all New Zealand telephone exchanges.WarningNo '111' or other calls can be made from this device during a mains power failure.7. This equipment may not provide for the effective hand-over of a call to another device connectedto the same line.Xerox® VersaLink® B605/B615 Multifunction PrinterB-12User GuideRegulatory Information
