YASKAWA VIPA System SLIO Manual

Contents

YASKAWA VIPA System SLIO Manual Manual pdf 187 page image

n Starting point of the SSW timer is newly started. Onlywhen the measured signal is longer than the time SSWwithin the range of values SST, steady state is set.[1] SSW timer has expired and the measured signal iswithin the range of values à Steady state bit is set.[2] Measured signal exceeds the range of values àSteady state bit is reset.[3] SSW timer has expired and the measured signal iswithin the range of values à Steady state bit is set.[4] Measured signal exceeds the range of values àSteady state bit is reset.3.16.9 DiagnosticsVia the parameterization you may activate a diagnostic interrupt for the module. With adiagnostics interrupt the module serves for diagnostics data for diagnostic interruptincoming.As soon as the reason for releasing a diagnostic interrupt is no longer present, the diag-nostic interruptgoing automatically takes place. All events of a channel between diagnosticinterruptincoming and diagnostic interruptgoing are not stored and get lost. Within this timewindow (1. diagnostic interruptincoming until last diagnostic interruptgoing) the MF-LED of themodule is on.The following events can cause a diagnostic interrupt:n External auxiliary supply is missingn Internal diagnostic puffer overflown Internal communication errorn Project engineering/parametrization errorn Measuring range underflown Measuring range overerflowDS - Record set for access via CPU, PROFIBUS and PROFINET. The access happensby DS 01h. Additionally the first 4 bytes may be accessed by DS 00h.IX - Index for access via CANopen. The access happens by IX 2F01h. Additionally thefirst 4 bytes may be accessed by IX 2F00h.SX - Subindex for access via EtherCAT with Index 5005h.More can be found in the according manual of your bus coupler.Diagnostic dataVIPA System SLIO Analog Input031-1CA20 - AI 1x16(24)Bit Strain gauge (DMS) > DiagnosticsHB300 | SM-AIO | | en | 17-05 187