7. After mounting the whole system, to protect the backplane bus connectors at thelast module you have to mount the bus cover, now. If the last module is a clampmodule, for adaptation the upper part of the bus cover is to be removed.2.5 Wiring periphery modulesCAUTION!Do not connect hazardous voltages!If this is not explicitly stated in the corresponding module description,hazardous voltages are not allowed to be connected to the correspondingterminal module!With wiring the terminal modules, terminals with spring clamp technology are used forwiring. The spring clamp technology allows quick and easy connection of your signal andsupply lines. In contrast to screw terminal connections this type of connection is vibrationproof.Umax 240V AC / 30V DCImax 10ACross section 0.08 ... 1.5mm2 (AWG 28 ... 16)Stripping length 10mm1 Pin number at the connector2 Opening for screwdriver3 Connection hole for wireTerminal module terminalsDataWiring procedureVIPA System SLIO Basics and mountingWiring periphery modulesHB300 | SM-AIO | | en | 17-05 21
