23Basic OperationCommunicationLet’s try communication using the FT1DR in the analog communication mode.Follow the procedure below.Turn the power on.Adjust the volume level.Select an operating band.Select a frequency (band).Tune in to a frequency.Start communication.Turning on the Power1 Press and hold the P switch over 1 second.An opening message is displayed, and then two frequencies (A-band frequency andB-band frequency) are displayed at the same time.Hints You can change the information such as the power supply voltage and the opening messagedisplayed at power-on. Press and hold the M key over 1 second to select the Set mode, andthen select “1 DISPLAY” “7 OPENING MESSAGE”.In addition, you can cause the FT1DR to display the reception frequency immediately withoutdisplaying the opening message (See page 154). Turning off the PowerTo turn off the power, press and hold the P switch over 1 second.