54Scanning FunctionUsing the Scanning FunctionScanning Only the Selected Memory Channel1 Select the Memory mode, and then recall the selectedmemory channel.2 While pressing the B key, turn the O knob to specifythe scanning range.Hints For the scanning range to be specified, see the table on page66.3 Release the B key.Hints • Scanning (SCAN) is performed toward higher memory channel numbers.• Only the selected memory channel is scanned.• If a signal is received during scanning, a beep is emitted and scanning stops for 5 secondsto receive the current frequency.• While scanning is suspended, the decimal point blinks and the display stays lit.• After receiving the frequency for 5 seconds, scanning resumes.• To cancel scanning, press the p key briefly.Scanning a Memory BankOnly the memory channels in the recalled memory bank can be scanned.1 Press the V key.The Memory mode is selected.2 Press the B key briefly.Recall a memory bank.Pressing the B key briefly toggles between “MEMORY NO.” and “BANK (No.)”.Hints To recall another memory bank, press the F key briefly, and the press the B key briefly.3 Turn the O knob to select a memory bank.Select a memory bank from among BANK 1 to BANK 24.4 Press the B key briefly.The selected memory bank is determined.5 While pressing the B key, turn the O knob to specify the scanning range.Hints For the scanning range to be specified, see the table on page 66.6 Release the B key.Scanning (SCAN) is performed toward higher memory channel numbers.Hints • Turn the O knob clockwise.:Scanning is performed toward higher memory channel numbers.Turn the O knob counterclockwise.:Scanning is performed toward lower memory channel numbers.• When a signal is received during scanning, scanning stops for 5 seconds and this frequencyis received.• When scanning is suspended, the decimal point blinks and the LCD stays lit.• After receiving the frequency for 5 seconds, scanning resumes.• To cancel scanning, press the p switch.
